COP-USA CD66MK-HW - Manual (Page 7)

- 4 -
1.3 Dome Functions
Multi protocol decoder integrated
a. built-in the multi protocol decoder, including maximum 16 protocols with optional baud rates
from 2400bps to 19200bps.
b. RS485 data communication, dome addresses (ID): 1
～511.
Omni bearing Pan/tilt
a. 360º panning, panning speed: 0.2
～300rad/s,
b. 0
～90º tilting，tilting speed: 120rad/s,
c. low speed running smoothly, low noise.
Intelligent functions
a. 128 preset positions, power off memory function.
b. Line scanning function, with adjustive speed.
c. 6 cruising tracks, each cruising track has 16 preset positions with adjustive residence time.
d. 3 Pattern tours, 120 seconds for each, with power off memory function.
e. Alarm function, 4 alarm in and 1 alarm out.
f. Angle display, including the panning, tilting and camera view angles.
g. Power recovery.
h. Temperature display.
i. Password protection for the menu.
j. Long distance dome address modification. The address of the dome can be modified by RS485,
the rules are as the following.
k.The dip switcher address is the hardware address (HID), the address we change by RS485 is the
software address (SID).The HID and SID is same when we produce it. (ie: HID=SID=001) If
we change the SID to 002 by RS485, then the address of the dome is 002. And this address is
power off memory.But if then, we change the HID to 003 by dip switcher, the HID and the SID
are all 003. It means the address of the dome will be same with the HID or SID which we
changed at the last.