COP-USA DVR2716XD-L - Manual (Page 32)

DVR User Manual
26
Step3: The setup steps of motion trigger are similar to „Alarm Handling‟. You can
refer to Chapter 4.5.1 Sensor Alarm Handling for more details.
Step4: Click “Setting” button under the Area to display the following picture as
shown in Fig 4-21:
Step5: In the Area tab, you can drag slide bar to set the sensitivity value (1-8). The
higher the value is the more sensitive it is to motion. Since the sensitivity is
influenced by color and time (day or night), you can adjust its value according to the
practical conditions. Left click the grid and drag to delete area. Drag again to add
area. Click icon to set the whole area as detection area. Click icon to clear
the set detection area. Click icon to test the sensitivity as per the local
conditions. Once motion is sensed, it displays a figure icon. Click icon to save
the setting. Click icon to exit the current interface. Fig 4-21 Motion-Area
Note: Prior to setting motion detection field it is recommended that you click icon to clear the existing field and set afresh.
Step6: Select “All” to setup all channels with the same parameters.
Step7: Click “Apply” button to save the setting.
Step 8: Enter into Schedule tab. The setup steps for schedule for motion based
alarm are similar to normal schedule setup; you can refer to 4.4.1 Schedule for
details. This step is very important for motion based alarm. Even if you have
enabled the motion based alarm for all channels and setup the trigger, you will
not see the result of motion based alarm if no schedule is added.
If you have set the schedule for sensor based recording in the same timeline,
recordings can also be triggered.
Fig 4-22 Motion-Schedule