COP-USA DVR2716XD-L - Manual (Page 36)

DVR User Manual
30
Send address/password: Sender‟s email address/password
Receive address: Receiver‟s email address. Here user can add at least three mail addresses.
Click TEST button to test the validity of the mailbox.
Attaching image: After selecting it, the system will attach images when sending the
emails.
4.6.4 Server
This function is mainly used for connecting ECMS. The setting steps are as follows:
Step 1: In the server tab, select “enable” as shown in the Fig 4-29.
Step 2: Check the IP address and port of the transfer media server in the ECMS. The default
server port for auto report is 2009. If it is modified, please enter into the transfer media
interface to check. Fig 4-28 Network Configuration-Email
Step 3: Enable the auto report in the ECMS when adding a new device. Then input the
remaining information of the device in the ECMS. After that, the system will auto allot
a Device ID. Please check it in the ECMS.
Step 4: Input the above-mentioned server IP, server port and device ID in the server
interface .Then click “Apply” button to save settings. Now, the ECMS system will
automatically connect this device.
Fig 4-29 Network Configuration-Server
4.6.5 Other Settings
If your DVR is setup to use PPPoE as its default network connection, you may setup DDNS to be used in connection. The setting steps are
as follows:
Step 1: Select Other Settings tab. Enable DDNS server.
Step2: Select DDNS server.