COP-USA DVR2716XD-L - Manual (Page 33)

DVR User Manual
27
4.5.3 Video Loss
Step1: Enter into MenuSetupAlarmVideo Loss tab. Refer to Fig 4-23:
Step2: The setup steps of video loss trigger are similar to alarm handling. You can refer to
Chapter 4.5.1 Sensor alarm handling for more details.
Step3: Click “Apply” button to save the setting; click “Exit” button to exit the current
interface.
Fig 4-23 Video Loss
4.5.4 Other Alarm
This tab gives a choice to configure alarm for Disk Full, IP Conflict, the
Disconnect event, Disk Attenuation or Disk Lost.
Step1: Enter into MenuSetupOther alarm tab. Refer to Fig 4-24:
Step 2: Use the dropdown menu and select the event or the alarm.
Step 3: Check the required trigger options.
If the selected event is “Disk Full”, then use the drop down box for “Disk
Shortage Alarm” to choose a threshold value for remaining HDD space. If the
threshold value is reached, the system will trigger the Disk Full Alarm.
Click “Apply” to save settings; Click “Exit” to exit the current interface
Fig 4-24 Other Alarm
4.5.5 Alarm Out
Alarm out includes three sub menus: alarm out, schedule and buzzer
To setup alarm out:
Step 1: Enter into MenuSetupAlarm out tab. Refer to Fig 4-25. Input relay name and hold time.
Step 2: Select the Schedule tab. This will bring up the schedule setup interface. The setup steps for schedule for alarm out are similar to
normal schedule setup; you can refer to 4.4.1 Schedule for details.