COP-USA DVRMPEG4-16LAN - Manual (Page 11)

2.2.2 Install tool
One cross-screwdriver
2.2.3 Install process
⑴ Open the DVR by screwdriver
⑵ Set one as master and the other as slave if two HDDs are connected to one ATA interface!!!
Attention :
Same HDD connected to parallel cable can not be set as master+master or slave+slave,
must be master+slave!!!
HDD setup: Take the HDD of Maxtor (DiamondMax Plus 8 ATA/133 40GB) as example.
Read the jumper cutline in the rear of HDD
No jumper=DS(SLAVE)
DS(MASTER)
CS
Enabl
e
Ca
p
l
imi
t
11