5 spot – COP-USA DVRMPEG4-16LAN User Manual
Page 84
84
Select the record and press “Enter” button to view this record.
Use “Up” “Down” to choose the file record, Press enter button to view the record chosen, the “Forward”
“Backward” “Play/pause” buttons can be used to control the record. Press “stop” button to back to live picture
If the event file list is too much, user can move to the page needed though “PGUP” “PGDN” “LAST”
“FIRST”, the meaning of these signs and shortcut keys is in the table above.
The record was divided into many sections automatically. The default length of one section is ten minutes
(600 Seconds). Length may be shorter than 1 hour, depending on actual motion recording, alarm recording
and schedule setup.
3.5 SPOT
Connect the DVR to a SPOT monitor by the SPOT port first, and then press the “SPOT” button on the
remote controller to setup. (Fig3.5.1 SPOT setup)
There are four options to choose: CHANNEL, SEQ SINGLE, SEQ QUAD and SEQ STOP.
If you choose “CHANNEL”, then you should choose the channel number in the blank below. The spot
monitor will output the image of the channel chosen all along.
If you choose “SEQ SINGLE”, the spot monitor will output images of all the channels circularly one by
one.
If you choose “SEQ QUAD”, the spot monitor will output images of all the channels circularly by quad.
If you choose “SEQ STOP”, the spot monitor stops sequence playing.