COP-USA DVRMPEG4-16LAN User Manual
Page 46
46
Backup.
If you choose “OFF”, this function is disabled.
SETUP-REC-EVENT: Setup of the event record (Fig3.2.16 Setup event record)
MOTION DETECTION (Fig3.2.17 Setup motion detection):
AREA
: This is the detection area setup
There are three options to choose: ALL, PART, OFF
ALL: All area will be detected.
PART
: The part selected will be detected. Use the “Up” “Down” “Left” and “Right” to choose the part
needed to be detected and use enter key to select/cancel the part. The part selected will be in blue and gray
part will not be detected.
OFF: This function will be disabled.
SEN
: This is the sensitivity of the motion detection. You can use remote controller or the number button
on front panel to set any value of sensitivity from 0 to 9. The value is bigger, the sensitivity is higher.