Hardy HI 1756-FC User Manual
Hi 1756 fc feeder control module user’s guide
Advertising
Table of contents
Document Outline
- Contents
- Chapter 1 Overview
- Chapter 2 Specifications
- Basic Specifications
- General
- Resolution
- Input
- Non-Linearity
- Common-Mode Rejection
- Common-Mode Voltage Range
- Backplane Input Voltage/ Power Load
- Backplane Current Load
- Backplane Power Load
- C2 Calibration Input
- Cable lengths
- C2® Maximum Cable Length
- Load Cell Excitation
- C2 Calibration Output
- Number of Channels
- Update Rate
- Averages
- WAVERSAVER®
- Digital Voltmeter (IT)
- Power and Utility Requirements
- Environmental Requirements
- Pending Approvals
- Parameter Defaults
- General
- Basic Specifications
- Chapter 3 Installation
- Chapter 4 Configuration
- Power Check
- Setting Up Communications
- Configuration Output Table Overview
- First Word - 0: Command Number
- Second Word - 1: Format Word
- Third / Fifth Words - 2, 3, 4: Parameter Number and Value
- Parameter 2 Metric (Unit of Measure)
- Parameter 3 Span Weight
- Parameter 4 Cal low weight
- Parameter 5 ROC time base
- Parameter 6 ROC time units
- Parameter 7 Averages
- Parameter 8 WAVERSAVER®
- Parameter 9 Rate Calibration Configuration PID P
- Parameter A Rate Calibration Configuration PID I
- Parameter B Batch amount
- Parameter C Preact
- Parameter D Mode
- Parameter E Prime Time
- Parameter F Pause Time
- Parameter 10 Feed Time
- Parameter 13-18 Refills
- Initial Refill
- Parameter 11 Initial Refill on
- Parameter 12 Auto Refill On
- Parameter 13/14 Refill Start Weight and End Weight
- Parameter 15/16 Refill Shutdown and Refill Too High Weight
- Parameter 17 OP Adjust
- Parameter 18 OP Adjust %/wgt during refill
- Refill OP Adjust %/wgt
- Parameter 19 Wait Time
- Parameter 20 Low Alarm Shut Down Rate
- Parameter 21 High Alarm Shut Down Rate
- Parameter 22 Alarm Delay
- Parameter 23 Rate Setpoint
- REC Parameters
- Rate Calibration Parameters
- Input Table
- Chapter 5 Calibration
- Chapter 6 Troubleshooting
- Index