Hardy HI 1756-FC - Manual (Page 18)

Configuration Output Table Overview
To configure the module, you send commands via the PLC output table.
The 1756 module uses 32 16-bit INT words in and out. Only 5 words of the output table
are normally used. (Command 0X5E uses ten and 0X5F uses seven)
13
●
●
Chapter 4
Word Command structure write
0 Command number
1 Format word (see Format Word below)
2 Value (LSW)
3 Value (MSW)
4 Parameter ID
Parameters can be read (READPARAM) or written (WRITEPARAM) one at a time:
 To read a parameter, put the readparam command number in word 0, the format
word in word 1, and the parameter’s number in word 2 of the output table.
 To write a parameter, put the writeparam command number in word 0, the
format word in word 1, and the parameter’s value in words 3 and 4 of the output
table.
First Word - 0: Command Number
The first word in the output table is a command. The possible commands are:
Command # Hex Description
NOCMD 0 No command
STARTCMD 1 START
STOPCMD 2 STOP
REFILLCMD 3 REFILL
WRITENONVOLATILE 4 Saves all parameters (including calibration
constants) to the non-volatile memory. Error Return
Values: None
MANUALCMD 5 Enters manual mode
ABORTCMD 6 Stop, go straight to IDLE mode
RELOADNONVOLATILE 0x10 Causes the weigh module to re-read the values
stored in its non-volatile memory. Parameters
changed since the last write non-volatile command
are overwritten. Can be used to abort a calibration
or parameter entry session. No error return values.
RATE_CAL_5_POINTS_
DEFINED 0x5E Runs the 5-point rate calibration at percentage
outputs defined at words 2-6. The percentages have
0 decimal places. They must be > 0, < 100, and in
ascending order, with a minimum of 10 between
them.
RATE_CAL_2_POINTS_
DEFINED 0x5F Runs the 2-point rate calibration at percentage
outputs defined at words 2-3. The percentages have
0 decimal places, and must be > 0, < 100, and in
ascending order, with a minimum of 10 between
them. This calibration operates at points 2 and 4 of
●
●
●