Hardy Enviro Bench Scales - Manual (Page 34)

Section 7: Operations
12/09 29 0596-0315-01 Rev B
23. The entire under bar graph, the entire accept, and the first segment of the over bar graph will be
illuminated. A previously programmed weight value is displayed with the leftmost digit flashing.
This is the end of accept point. If required using the same procedure as identified in step 21 above,
enter the correct value for the end of the accept range. When the correct end of accept value is
displayed, press program/enter.
24. The entire under bar graph, the entire accept, and the entire over bar graph will be illuminated. A
previously programmed weight value is displayed with the leftmost digit flashing. This is the end of
over point. Using the same procedure as identified in step 21 above, enter the correct value for the
end of the accept range. When the correct end of over value is displayed, press program/enter.
25. The indicator will briefly display CSaved; then return to the weigh mode with the most recently
configured recipe active.
Checkweigh mode operation:
1. With the scale empty, press zero to zero the display if required.
2. Press the appropriate recipe button to enable the Checkweigh mode and that recipe. If recipe is
enabled, the indicator above that button will illuminate.
3. Place object to be weighed on the bench scale. The appropriate LED’s in the bar graph will illuminate
to show the weight of the object relative to its target acceptance range. If no green LED’s are lit up,
the object is under the target weight. If some of the green LED’s are lit, the object is within the
acceptance range. If one or more red LED’s light up, the object is above the acceptance range.
4. When finished Checkweighing, simply press the recipe button that was enabled to exit Checkweigh
mode, or press a different recipe button to use a different programmed recipe.