Jumper and switch settings – Clarion UNGO MS8200 User Manual
Page 14
Page 12 - MS8200 / MS8300 Installation Manual
Jumper Selections
Cancel Auto Rearm. Disables the Automatic Rearm Feature.
On = Auto Rearm Disabled
Off = Auto Rearm Enabled
Parking Light Polarity. Selects the polarity (+/-) for the output of the on-board Parking Light
relay.
Pin 1 + Pin 2 = positive
Pin 2 + Pin 3 = negative
Dome Light Polarity. Selects the polarity (+/-) for the output of the on-board Illuminated
Entry/Exit relay.
Pin 1 + Pin 2 = positive
Pin 2 + Pin 3 = negative
Auxiliary Function 1 Polarity. Selects the polarity (+/-) for the output of the on-board
Auxiliary Function 1 relay.
Pin 1 + Pin 2 = positive
Pin 2 + Pin 3 = negative
Programming Switches
1. Door Lock Pulse Width. Selects between a 1-second and a 4-second output for door locking
and unlocking. Set to 4 seconds when interfacing into vehicles equipped with vacuum door
locking systems.
2. Passive Locking. When the switch is on, the system will automatically lock the doors with
Auto Rearm and Passive Arming.
3. Ignore Delayed Domelight. For use with vehicles equipped with a timed dome light circuit
that stays on after door has been closed. When the switch is on, the system will ignore the
dome light circuit during arming to prevent the system from responding with an open zone
indication each time the system is armed.
4. Horn Honk / Arming Output. Selects between pulsed or constant output for the Orange/blue
wire.
5. Comfort Closure. Sets the system to provide a 40 second output on the door lock wire
(White/green (-) or White/blue (+12v)) when the system is Armed to activate the Comfort
Closure feature found on many late model European vehicles. Vehicles equipped with this
feature will normally close the windows and sunroof automatically when the door key is held
to the lock position.
6. Remote Space Shield III Adjustment. Enables remote sensitivity adjustment of the Space
Shield III (included with the MS8300) when connected to the 4-pin Optional Sensor harness.
Jumper and Switch Settings
installation_rev3.qxd 7/26/99 6:07 PM Page 12