A&D Weighing SG-30KA - Manual (Page 16)

15
SF/SG Series Operating Instructions
Step 6: Press the PLU 2 key. The data will be sent to the printer and the scale will return to the normal
weighing mode. If the scale will not return to the normal weighing mode, check the values
entered.
Step 7: Using the numerical keypad, enter “1”, “0”, “0”, “6”, “2”, “0”, “0”, “1”, “0”, “9”, “4” and “5” in
this order. If an error is made, press to clear the values. And re-enter the values.
SF series SG series
Step 8: Press the PLU 3 key. The data will be sent to the printer and the scale will return to the normal
weighing mode. If the scale will not return to the normal weighing mode, check the values
entered
14-4 Combining the designed data with a PLU number
Assign a PLU number to a label number of the designed data stored in the AD-8124 as follows:
Example: Assign the PLU number 5 to the label number 12.
Step 1: While holding down , turn the scale’s power switch on. Assure that the printer
power switch is turned on.
The WEIGHT display reads “
Se t Ln
” . A 3-digit label number “
000
” appears in the PRICE
display for the SF series scale and in the UNIT PRICE display for the SG series scale.
SF series SG series
C
1006 2001 0945
WEIGHT UNIT PRICE PRICE 1006 WEIGHT
2001
UNIT PRICE
0945
PRICE
Note:
The label numbers are the same as the PLU numbers at the time of printer shipment.
M+
se t ln 000
WEIGHT UNIT PRICE PRICE se t ln
WEIGHT
UNIT PRICE
000
PRICE
AD-8124 continued...