A&D Weighing SG-30KA - Manual (Page 8)

SF/SG Series Operating Instructions
4. Setting a Unit Price
Step 1: Enter a unit price using the numerical keypad. Up to 6 digits may be entered.
Example: Enter a unit price of $5.50
Step 2: Unit price entry must be completed within 3 seconds. Any delay beyond 3 seconds
will require the unit price to be re-entered.
Note about keypad tare entry:
• When a TARE weight has been set, an error message “ Err tr ” will appear as shown below, if you
enter a lower value than the TARE weight.
• If you enter a TARE weight greater than the weighing capacity of the scale, an error message “ Err tr ”
will appear as shown below.
• To release the error shown above, press to return to the weighing mode.
• Any previous TARE entries will be cancelled when is pressed.
• To cancel a TARE weight that has been entered, remove any weight from the weighing pan
and press .
0
ZERO
T
TARE
NET ZERO
0.000
WEIGHT UNIT PRICE
------
PRICE
Err tr
0.000
WEIGHT
NET ZERO
UNIT PRICE
5.50
PRICE
0.00
7
MODE
(
(