AERCO KC1000 Heater 2002 - Manual (Page 9)

INSTALLATION
2-1
SECTION 2 - INSTALLATION
2.1 RECEIVING THE UNIT
Each KC1000 Heater is shipped as a single
crated unit. The unit shipping weight is approxi-
mately 1500 lb. and must be moved with the
proper rigging equipment for safety and to avoid
damage. The unit should be completely
inspected at the time of receipt from the carrier
before the bill of lading is signed. Each unit has
Tip-N-Tell indicator on the outside of the crate.
This indicates if the unit has been turned on its
side.
If the Tip-N-Tell indicator is tripped, do not sign
for the shipment. Note the information on the
carrier’s paperwork and request a freight claim
and inspection by a claims adjuster before
proceeding. Any other visual damage to the
packaging materials should also be made clear
to the delivering carrier.
2.2 UNPACKING
Carefully unpack the unit. Take care not to
damage the unit jacket when cutting away
packaging materials. A close inspection of the
unit should be made to determine if there has
been any damage incurred during shipment that
was not indicated by the Tip-N-Tell indicator.
The freight carrier should be notified immediately
if any damage is detected. The following acces-
sories come standard with each unit and are
packed separately within the unit’s packing con-
tainer
• Spare Spark Ignitor
• Spare Flame Detector
• Manual 1-1/4" Gas Shutoff Valve
• Drain Valve Assembly
• ASME Pressure/Temperature
Relief Valve
• Ignitor Removal Tool (1 per Site)
• Regulator Adjustment Tool (1 per Site)
• 2 Lifting Lugs
• Stainless Steel Condensate Cup
• Flue Clamps (2 Pieces)
• Shell Cap
• Wing nut for shell cap
Optional accessories are also separately packed
within the unit’s packing container. Standard and
optional accessories shipped with the unit should
be identified and put in a safe place until
installation/use.
Figure 2.1 Heater Clearance