Antari X-310 PRO - Manual (Page 10)

10
In order to use 1 transmitter to control 2 or more machines, turn on the machines respectively.
When the displays indicate »Wireless Setup«, press the button “A” 1 second on the transmitter
within 15 seconds to establish the signal transmission.
-Battery change on the transmitter
If the range of the transmitter decreases, the battery is probably exhausted and must be replaced.
For this purpose, take off the housing cover and remove the used battery. Insert a fresh DC 12V
battery as indicated in the battery compartment and refit the housing cover.
Switching the wireless function on and off
Press the button FUNCTION until the display indicates »Wireless On«. Use the buttons UP and
DOWN to deactivate the wireless function (indication »Wireless Off«) and to reactivate it
(indication »Wireless On«).
 Note: When warming-up process is completed and wireless function is activated the
LCD screen indicates “Ready To Faze W”. (“W” means Wireless) On the contrary, when
the wireless function is deactivated the LCD screen shows “Ready To Faze” (Without
“W”).
X-30PRO REMOTE CONTROL EXTERNAL VIEW
02 L.C.D Screen .
03 Function Keypad .
04 Cable For Remote Control
(2m / 5-pin)
.
05 Receiver .
06 Transmitter .
01 Thumb Screws .
OFF
ON