Antari X-310 PRO - Manual (Page 5)

5
Optional Accessories:
1. X-30PRO Wireless Control Module
2. FX-310 X-310PRO Flightcase
-Setup
1. Remove all packing materials from shipping box. Check that all foam and plastic padding is
removed, especially in the nozzle area.
2. Place fog machine on a flat surface and remove fog liquid tank cap.
3. Fill with only Antari Fog Fluid. Antari X-310PRO Fazer only works with uncontaminated Antari
FLG Fog Fluid. Other fluids may cause spitting and serious clogging problem and could result
in the production of an unhealthful fog. The use of other fluids will void the warranty of the
Antari X-310PRO Fazer. When filled, place cap back on liquid tank.
-Operation
1. The plug is at a position that is accessible when the machine is in use.
2. Plug power cord into a grounded electrical outlet. Turn power switch on rear of unit to "
ON" position. Warm-up is complete after approx. 8 minutes when the display on the control
module indicates "Ready to Fazer”.
3. To emit fog, please set the desired settings on your X-10PRO Control Module for interval,
duration, and press the appropriate button on the control module for the desired
length of time.
4. The control unit's display will cycle "Warming up" and "Ready to Fazer" while the machine
re-heats to the proper operating temperature.
5. When the fluid is running low, the LED inside the tank chamber starts blinking for two minutes
and then stops the operation to protect the pump from running dry.
6. The “Fanleaf” design can be adjusted by the pump-type screws on both sides to position the
faze output angle. In general, the haze produced from the X-310PRO Fazer is
semi-transparent due to fan spread. Thus, it is best to position it on the low ground and let it
produce haze upwardly to have ideal coverage.
7. For further information on operating your ANTARI X-310PRO Fazer, see the section titled,
"Control Module Operation" on page 4.
Caution: "Visibility during operation is reduced"
Important:
Always monitor tank fluid level as you are fogging. Running a fog machine with no fluid can
permanently damage the pump.
If you experience low output, pump noise or no output at all, unplug immediately. Check fluid level,
the external fuse, control module connection, and power from the wall. If all of the above appears
to be O.K., plug the unit in again. If fog does not come out after holding the button down for
MANUAL