Antari X-310 PRO - Manual (Page 6)

6
30 seconds, check the hose attached to the tank to make sure there is fluid going through the hose.
If you are unable to determine the cause of the problem, do not simply continue pushing the
control module button, as this may damage the unit. Return the machine to your ANTARI dealer
immediately.
-Antari X-10PRO Control Module Operation
X-10PRO: The X-PRO is a 2-meter wired multifunction remotecontrol module with 5-pin XLR
connector for ANTARI X-PRO series model X-310PRO. Its LCD panel displays all
operation statuses of the fog machine. The interface allows the operator to customize
fog machine functions by adjusting the fogging duration, interval, volume, fan and
heater as well as the DMX address . There are six buttons on the control board. All
current operating parameters are automatically stored in non-volatile memory,
allowing the machine to be powered down without losing function settings.
-Menu Settings With The Button FUNCTION
Setting time intervals for timer operation
Press the button FUNCTION until the display indicates » Interval Set « . Use the buttons UP
and DOWN to adjust the intervals between the individual fog outputs in timer mode
within the range of 1 and 200 seconds.
Setting the output duration for timer operation
- Press the button FUNCTION until the display indicates » Duration Set «. Use the buttons UP
and DOWN to adjust the duration of the fog outputs in timer mode within the range of 1
and 200 seconds.