Antari X-310 PRO - Manual (Page 4)

4
 Never aim the output nozzle directly at people.
 Machine will warm up when operating, locate the fog machine in a well-ventilated area.
Never cover the unit's vents. In order to guarantee adequate ventilation, allow a free air space
of at least 30 cm around the sides and top of the unit.
 Never aim the output nozzle at open flames.
 Always allow your ANTARI X-310PRO Fazer to cool down before attempting to clean or service
it.
-Danger of Explosion

Never add flammable liquids of any kind (oil, gas, perfume) to the fog liquid.
 Use only the high-quality, water-based ANTARI recommended FLG fog liquid. Other fog liquids
may cause clogging or damage the internal parts.
 Always make sure there is sufficient liquid in the fog liquid tank. Operating this unit without
liquid will cause overheating.
 If your ANTARI Fog Machine fails to work properly, discontinue use immediately.Drain all fog
liquid from the tank, pack the unit securely (preferably in the original packing material), and
return it to your ANTARI dealer for service.
 Always drain tank before mailing or transporting this unit.
 Never drink fog liquid.If it is ingested, call a doctor immediately.If fog liquid comes in contact
with skin or eyes, rinse thoroughly with water.
Important:
Pay attention to all warning labels and instructions printed on the exterior of your ANTARI
X-310PRO Fazer.
-Unpacking & Inspection
Open the shipping carton and verify that all equipment necessary to operate the system has
arrived intact.
Before beginning initial setup of your ANTARI Fazer Machine, make sure that there is no evident
damage caused by transportation. In the event that the unit's housing or cable is damaged, do not
plug it in and do not attempt to use it until after contacting your ANTARI dealer for assistance.
-Packaging
The shipping carton should include the following items:
1. X-310PRO Fazer machine with power cable
2. X-10PRO Control module
3. Fluid tank
4. User manual