Antari X-310 PRO - Manual (Page 14)

14
-DMX Connector Pin Assignment
The machine provide 3 or 5 pin XLR connector for DMX connection. Diagram below indicate pin
assignment information
Pin Function
1 Ground
2 Data-
3 Data+
-ANTARI X-310PRO on-board DMX settings
C h a n n e l A
6-255 (5%-100%)
0-5 (OFF)
C h a n n e l B
86-170 (MEDIUM)
0-85 (SLOW)
Volume out put Fan Speed
171-255 (FAST)
The X-310PRO Fazer has on-board DMX control. This model uses 2 channels to control Volume
output operation and Fan operation. Whatever channel you select on the unit, the channel next to
it will be automatically selected for fan volume control. Each channel has a value range of 0 to 255.
Timer functions such as duration and interval can be programmed using the DMX controller or the
DMX control software being used by lighting and effects operator.
If Channel B has a value from 0 to 5,
The unit is OFF.
Between the values 6 to 255 the volume of fog output is regulated. With 6 being the minimum
volume of fog produced and 255 approaching the maximum. The volume output rises as the DMX
value is increased.
Note: If the machine was assigned to the DMX address 124 e.g., Channel A would correspond to
DMX address 124 and channel 125 will automatically be selected for fan control.
The Nonstop Burst Function (continuous fog output) cannot be controlled or set via DMX.