Antari X-310 PRO - Manual (Page 9)

9
Press the button “A”, to emit fog. The button “A” has the same function as the button VOLUME on
the control panel, i.e. the fog output depends on the setting of menu item »Volume Out«. The
display indicates »Volume« followed by the defined value or »NON STOP BURST« when continuous
fog output was selected. To stop the fog output, press the button “B”.
* Receiver:
The receiver is tested and pre-attached to the panel of each Z-30PRO. Please do not try to remove
it. The receiver responds to up to 5 different transmitters that are registered with the machine. The
included transmitter has been registered to the machine before shipment. It can be directly
operated without any start-up setting.
-Registering transmitters
To operate the machine with a different transmitter than the included one, or to operate it with up
to 5 different transmitters, each transmitter must be registered first. For this purpose, turn on the
machine. When the display indicates »Wireless Setup«, press the button “A” 1 second on each
transmitter. Thus the previous transmitters are cleared from the memory of the receiver. The
setting must be completed within 15 seconds after switching on the machine. Then the machine
will automatically exit the transmitter setting mode. The display shows »Wireless Setup OK«. At
this point, no further transmitter can be added.
If no transmitter is registered when the machine is switched on, the memory of the receiver will
keep the record of the previous operation.
Setting Example 1:
In order to register several transmitters with a machine, turn on the machine. When the display
indicates »Wireless Setup«, press the button “A” 1 second on each transmitter within 15 seconds
to establish the signal transmission.
Setting Example 2: