AvMap GEOSAT 4 TRUCK - Manual (Page 13)

13
flashes until the Geosat is fully charged.
ATTENTION when the device encounters
internal temperatures of higher than 60°,
the battery will not recharge and an alarm
message will be displayed. This can happen
if the navigator is exposed for a long time
to direct sunlight in hot weather. In such
cases, it is suggested that you switch off the
navigator to recharge the battery.
Battery Functioning
Geosat battery allows the navigator to
operate even without feeding it with the
power supply cable.
When the navigator is used without power
supply, an icon (battery) indicating the level
of charging of the battery is shown. If this
icon is half green, the level of charge of the
battery is equal or less than half, if the icon is
fully green, it means that the level of charge
is more than half.
When Geosat for ALL is fed, another icon
(plug with batteries) is shown. There are two
status: if the icon is coloured in yellow, the
battery is recharing, if the icon is coloured
in green, it means that the battery is fully
charged.
The maximum autonomy of the battery in
optimal conditions ranges from 30 minutes
to 2 hours (according to the usage patterns).
It is possible to extend the autonomy of the
battery optimizing the energetic waste: in the
system setup it is possible to choose among
three levels of power save (no, medium,
maximum).
3.1 Starting
1. Switch on the navigator by pressing the
POWER button.
2. Geosat will display the software and
cartography display screen and then the
user is asked to choose the desired mode:
passenger or driver. An unaccompanied
driver should select the Driver mode.
3. Select one of the two buttons with the
JOYSTICK using the left or right arrow.
The selected button is outlined by a dotted
line.
4. Press ENT to confirm.
5. Wait for the satellite search to be completed
to see your position on the map.
3. Set the destination