Bike2Power LightCharge - Manual (Page 10)

ENGLISH
10 | P a g e
Copyright © 2012 Bike2Power. All rights reserved
Connecting LightCharge to Bicycle Lights and Bottle Dynamo*
*
If installing LightCharge® for Hub Dynamo, skip to “Connecting LightCharge
USB Charger to Bicycle Lights and Hub Dynamo”, Page 11
Connectors
Bottom of dynamo
Front/rear lights wires
Dynamo electrical wire port
E2 LightCharge ground wire (Black)
E1 LightCharge electrical wire (Red)
E3 LightCharge lights connector (Yellow, clamp)
Connecting to the Dynamo and Bicycle Lights
Connecting to the Dynamo
Press on the dynamo’s electrical port so that the holes are aligned.
Insert the end of the red electrical wire (E1) into dynamo port, and release.
Slip the black ground wire (E2) over the dynamo adjustment bolt (C4) and
secure the bolt
Connecting to Bicycle Lights
Take the ends of the bike lights and twist them together
Insert the ends into LightCharge® lights connector clamp (E3)
Tighten the clamp
3
1
2
1
4
2
3
3
4