Bike2Power LightCharge - Manual (Page 13)

ENGLISH
13 | P a g e
Copyright © 2012 Bike2Power. All rights reserved
1. Twist LightCharge® ground wire and frame wire together
2. Insert the twisted wires into hub connector
3. Insert the LightCharge red wire into hub connector
4. Slightly bend and insert the connector into cover
5. Insert cover back into hub connections terminal
Disconnecting from a standard hub dynamo
To disconnect LightCharge® from the hub, follow the above steps in reverse.
Operating LightCharge®
Connecting mobile devices
Step 1. Place your mobile device into designated phone holder or another location
Step 2. Connect mobile device to charger
a. Use USB charging cable provided with your mobile device
b. Plug the USB end of your charging cable into the charger’s USB port
(A5)
Charging mobile devices
Step 1. Connect the mobile device to the charger
Step 2. Begin pedaling faster than 4 miles per hour which typically a walking speed
Light
Cable
Light Cable with Clamp (Yellow)
Electrical Cable (Red)
Grounding Cable (Black)
LightCharge Cables
Frame
Cable
1
3
2 4
5