Bike2Power LightCharge - Manual (Page 3)

ENGLISH
3 | P a g e
Copyright © 2012 Bike2Power. All rights reserved
Copyright
Copyright 2012© by Bike2Power. All rights reserved.
All brands and product names mentioned herein are the property of their respective
owners.
Introduction
LightCharge® USB Bicycle Charger allows charging USB-chargeable mobile devices and
bicycle lights while riding a bicycle. The device is designed to be used with the regular
(utility) bicycles.
LightCharge® is compatible with the majority of the smartphones makes and models
including Androids® and iPhones®. It is also compatible with USB and dynamo bicycle
lights.
LightCharge for hub dynamo is compatible with most common bicycle hub dynamos, while
LightCharge for bottle dynamo is compatible with a bottle (side) dynamo.
Charging with LightCharge® begins at as low as walking speeds. Install the device; connect
your mobile device to the 2.0 USB charger port using your mobile device USB charging
cable; connect bicycle lights to a designated LightCharge® connector and begin pedaling.
Read this guide carefully before installing and using LightCharge®. Review the user guide
for your bicycle, mobile device, bicycle lights, and hub dynamo before installing the
LightCharge® and connecting your chargeable devices.
Safety Instructions
(!) CAUTION
Obey your local laws. Always keep your hands free to operate the bicycle while cycling.
Road safety must be your first concern while cycling. Do not attempt to make or receive
calls, or operate your mobile device while cycling. Do not attempt to connect your mobile
device or lights to the charger while cycling. Always stop to initiate, modify, or terminate
any function on your mobile device and lights or to connect your mobile device and lights to
the charger.
Only operate LightCharge® if it is safe under the cycling conditions. Do not attempt to
remove or adjust any portion of LightCharge® while cycling. Always stop and loosen the
mounting mechanisms to adjust any portion of LightCharge®. Make sure all parts of
LightCharge® are secure before resuming your ride.
Allowing connector wire to hang loose is dangerous. Always secure the excess loose
connector wire away from the moving, steering, or braking parts of the bicycle.
When installing the LightCharge®, make sure that it does not interfere with or hinder any
of the bicycle moving, braking, or steering parts. Make sure that LightCharge® is installed
where you cannot come in contact with it in the event of an accident or collision. Always
make sure all parts of LightCharge® are securely installed before and after the ride. If you