English, Compatible devices – Bike2Power LightCharge User Manual

Page 4

Advertising
background image

ENGLISH

4 |

P a g e

Copyright © 2012 Bike2Power. All rights reserved

are not sure how to install any portion of LightCharge®, consult or hire a professional
installer.

Dynamo may become warm during operation. Do not touch the dynamo for a few minutes
after completing your ride.

Incorrect installation of the dynamo may cause it to fall between the wheel spokes and jam
the wheel. Always ensure that your dynamo is secure before and after the ride, and every
few miles during the longer rides.

Incorrect installation of the dynamo may cause an increase in the wear of a bicycle tire. If
you are not sure how to install the dynamo, consult or hire a professional installer.

The kits are impact resistant and water resistant, but not waterproof. Avoid submerging in
water or using in rain or snow without a protective cover. If LightCharge® becomes wet,
remove LightCharge® from the bicycle and allow it to dry out before reinstalling and using
again.

The connectors of this device may contain a small amount of nickel. Persons sensitive to
nickel may experience symptom from the prolonged skin contact with the connectors.

The kits may contain small parts which may constitute choking hazard. Keep them out of
reach of small children.

Read the installation instructions carefully. Do not attempt to substitute any parts of the
LightCharge®. Use LightCharge® only with the compatible mobile devices. Never force the
connectors into ports. Make sure that the connectors match a port and that you have
positioned them correctly.

These kits are not suitable for rough terrains or trick bicycling.

The kits may be affected by extreme temperatures. Always keep the kits between -15◦ C (5
F) and +55◦ C (131 F).

Bike2Power is not responsible for any damages or failure to the devices charged using the
LightCharge®. Bike2Power is not responsible for any damages or failures caused to the
bicycle used to mount the LightCharge®.


Compatible Devices

LightCharge® is compatible with 5v devices able to charge through USB and dynamo-
chargeable and USB-chargeable bicycle lights.

LightCharge® is compatible with the major smartphone makes and models as well as
Android® phones and iPhone®. LightCharge® may be connected to a hub dynamo or
bottle (side) dynamo.


Advertising