Bike2Power LightCharge - Manual (Page 12)

ENGLISH
12 | P a g e
Copyright © 2012 Bike2Power. All rights reserved
Disconnecting Lights from Hub Dynamo
1. Remove connector cover from hub dynamo
connection terminal
2. Remove connector from the cover
Connecting light(s) to LightCharge®
1. Remove light and frame cables from
connector
2. Cut approximately 3/8” to 1/2” from lights
cable to fit the LightCharge® lights
clamp
3. Insert lights cable into LightCharge
yellow clamp
4. Tighten the clamp
Connecting LightCharge® to dynamo hub
Light
Cable
Frame
Cable LightCharge Cables
Light Cable with Clamp (Yellow)
Electrical Cable (Red)
Grounding Cable (Black)
Frame
Cable
Light
Cable
LightCharge Cables
Yellow Clamp