Bike2Power LightCharge - Manual (Page 8)

ENGLISH
8 | P a g e
Copyright © 2012 Bike2Power. All rights reserved
Required Tools
2 Wrenches, 10 mm, regular, socket, or adjustable
Pliers, Scissors
Electrical tape and/or zip ties
Mounting
The dynamo may be mounted in any of the 4 positions shown below. Note that the
dynamo release lever must be facing the spokes. The installation steps below can be
applied to mounting in the either position.
Position “1” – L fork facing front
Position “2” – R fork facing rear
Position “3” – L seat stay facing front
Position “4” – Right seat stay facing rear
Step 1. Attach dynamo (B) to the exterior mounting bracket (C1)
a. Attach dynamo to the exterior mounting bracket (C1) using the
provided adjustment bolt (C4) with nut and washer.
b. Attach through dynamo’s bracket mounting hole (B4).
c. Tighten the bolt to achieve firm hold. Do not over-tighten.
Step 2. Attach the brackets (C1 and C2) to the front bicycle fork
a. Attach the mounting brackets (C1 and C2) to the bicycle fork. Interior
bracket (C2) should be positioned between the fork and the wheel.