CAMCORP CAM-AIRO Vertical Cartridge User Manual
Page 6
CAMCORP, INC.
Phone: 913-831-0740 Fax: 913-831-9271
www.camcorpinc.com
01(
- -
21
.
Baghouse, Bin Vent, Filter Receiver, Dirty Air Hopper and Housing
•
Housing can be stored outside.
•
Equipment must be blocked up to keep the flanges out of the dirt.
•
Most units are supplied with a plain unfinished interior. If storage of more
than two weeks is anticipated the interior should be prime coated before
storage.
•
Covering the unit with a tarp is recommended to help keep the interior
from rusting or corroding as well as keeping the outer finish in new
condition, however a tarp is not absolutely necessary.
Baghouse, Bin Vent, Filter Receiver, and Clean Air Plenum
•
Unit can be stored outside.
•
Compressed air header, diaphragm and solenoid valves must be tarped
for weather protection.
•
Position unit so water will not get in or remain inside the tube sheet area.
•
Unit must be blocked up to keep the flanges, bag cups, venturis and air
header out of water and dirt.
•
Ports on diaphragm and solenoid valves must be plugged and taped to
keep insects, dirt and moisture out.
•
For extended storage (more than 4 weeks), it is recommended to remove
the timer panel and solenoid valve assembly (if mounted). These
components should be stored inside a cool dry area along with the copper
or black nylon tubing. The solenoids should have all ports capped and
taped to protect from insects, dirt and moisture.
•
The unit should be tarped but is not absolutely necessary.
Pleated Filter Cartridges
•
As a standard, the filter cartridges are installed in the dust collector before
shipment.
•
If the dust collector will be stored outside for a period of time, the filter
cartridges must be uninstalled and stored inside a cool dry area protected
from moisture, rodents and insects.
•
If the filter cartridges get wet for any reason, immediately lay them out with
plenty of ventilation to dry in order to prevent mold and mildew.
2-2