Hazard warning flashers, Turn and lane-change signals – CHEVROLET 2013 Camaro User Manual

Page 152

Advertising
background image

Black plate (4,1)

Chevrolet Camaro Owner Manual - 2013 - CRC - 4/18/12

6-4

Lighting

headlamp system so that driving
under bridges or bright overhead
street lights does not affect the
system. The DRL and automatic
headlamp system will only be
affected when the light sensor sees
a change in lighting lasting longer
than the delay.

If the vehicle is started in a dark
garage, the automatic headlamp
system comes on immediately. If it
is light outside when the vehicle
leaves the garage, there will be a
slight delay before the automatic
headlamp system changes to the
DRL. During that delay, the
instrument cluster may not be as
bright as usual. Make sure the
instrument panel brightness control
is in the full bright position. See
Instrument Panel Illumination
Control on page 6‑5
.

Lights On with Wipers

If the windshield wipers are
activated in daylight with the engine
on, and the exterior lamp control is
in AUTO, the headlamps, parking

lamps, and other exterior lamps
come on. The transition time for the
lamps coming on varies based on
wiper speed. When the wipers are
not operating, these lamps turn off.
Move the exterior lamp control to

P

or

;

to disable this feature.

Hazard Warning Flashers

|

(Hazard Warning Flasher):

Press this button to make the front
and rear turn signal lamps flash on
and off. This warns others that you
are having trouble. Press again to
turn the flashers off.

Turn and Lane-Change
Signals

An arrow on the instrument cluster
flashes in the direction of the turn or
lane change.

Move the lever all the way up or
down to signal a turn.

Raise or lower the lever until the
arrow starts to flash to signal a lane
change. Hold it there until the lane
change is completed. If the lever is
briefly pressed and released, the
turn signal flashes three times.

The lever returns to its starting
position whenever it is released.

Advertising