CHEVROLET 2013 Camaro - Manual (Page 232)

Black plate (40,1) Chevrolet Camaro Owner Manual - 2013 - CRC - 4/18/12
9-40 Driving and Operating
These lights are on when the
vehicle is in the PTM Mode.
This optional handling mode can be
selected by pressing the TCS/
StabiliTrak button on the console
quickly two times. The appropriate
message displays in the DIC. See
Ride Control System Messages on
page 5‑38.
To experience the performance
benefit of this system, after entering
a curve and at the point where the
driver would normally start to
increase acceleration, the
accelerator pedal can be fully
pressed. The PTM system will
modify the level of engine power for
a smooth and consistent corner exit.
To select a mode while in PTM,
push the Selective Ride Control/
PTM − TOUR or + SPORT button
on the center console.
The PTM system contains five
modes. These modes are selected
by pressing the Selective Ride
Control/PTM TOUR − or SPORT +
button on the center console. The
driver scrolls up or down through
modes 1–5 by pressing the TOUR −
or SPORT + button.
The following is a DIC display
description and the recommended
usage of each mode.
PERF TRACTION 1 – WET /
ACTIVE HANDLING ON
. Intended for all driver skill levels.
. Wet or damp conditions only —
not intended for use in heavy
rain or standing water.
. StabiliTrak is on and engine
power is reduced based on
conditions.
PERF TRACTION 2 – DRY /
ACTIVE HANDLING ON
. For use by less experienced
drivers or while learning a new
track.
. Dry conditions only.
. StabiliTrak is on and engine
power is slightly reduced based
on conditions.
PERF TRACTION 3 – SPORT 1
/ ACTIVE HANDLING ON
. For use by drivers who are
familiar with the track.