Hazard warning flashers, Turn and lane-change signals, Hazard warning flashers on – CHEVROLET 2011 Suburban User Manual

Page 207: Hazard warning flashers -5 turn and lane-change, Signals -5

Advertising
background image

Black plate (5,1)

Chevrolet Tahoe/Suburban Owner Manual - 2011

Lighting

6-5

Hazard Warning Flashers

|

(Hazard Warning Flashers):

Press this button located on top of
the steering column, to make the
front and rear turn signal lamps
flash on and off. This warns others
that you are having trouble. Press
again to turn the flashers off.

When the hazard warning flashers
are on, the vehicle's turn signals will
not work.

Turn and Lane-Change
Signals

An arrow on the instrument panel
cluster flashes in the direction of the
turn or lane change.

Move the lever all the way up or
down to signal a turn.

Raise or lower the lever for less
than one second until the arrow
starts to flash to signal a lane
change. This causes the turn
signals to automatically flash
three times. It will flash six times if
tow-haul mode is active. Holding
the turn signal lever for more than
one second will cause the turn
signals to flash until you release
the lever.

The lever returns to its starting
position whenever it is released.

If after signaling a turn or a lane
change the arrows flash rapidly or
do not come on, a signal bulb could
be burned out.

Have the bulbs replaced. If the bulb
is not burned out, check the fuse.
See Fuses and Circuit Breakers on
page 10‑39
.

Turn Signal On Chime

If the turn signal is left on for more
than 1.2 km (3/4 of a mile), a chime
will sound at each flash of the turn
signal and the message TURN
SIGNAL ON will also appear in the
Driver Information Control (DIC).
To turn the chime and message off,
move the turn signal lever to the off
position.

Advertising