Jump starting, Jump starting -83, Vehicle care 10-83 – CHEVROLET 2011 Suburban User Manual

Page 457

Advertising
background image

Black plate (83,1)

Chevrolet Tahoe/Suburban Owner Manual - 2011

Vehicle Care

10-83

Jump Starting

For more information about the
vehicle battery, see Battery on
page 10‑28
.

If the vehicle is a Hybrid, see the
Hybrid manual for more information.

If the vehicle's battery (or batteries)
has run down, you may want to use
another vehicle and some jumper
cables to start your vehicle. Be sure
to use the following steps to do it
safely.

{

WARNING

Batteries can hurt you. They can
be dangerous because:

.

They contain acid that can
burn you.

.

They contain gas that can
explode or ignite.

.

They contain enough
electricity to burn you.

(Continued)

WARNING (Continued)

If you do not follow these steps
exactly, some or all of these
things can hurt you.

Notice: Ignoring these steps
could result in costly damage to
the vehicle that would not be
covered by the warranty.

Trying to start the vehicle by
pushing or pulling it will not
work, and it could damage the
vehicle.

1. Check the other vehicle. It must

have a 12-volt battery with a
negative ground system.

Notice: Only use a vehicle that
has a 12-volt system with a
negative ground for jump
starting. If the other vehicle does
not have a 12-volt system with a
negative ground, both vehicles
can be damaged.

2. Get the vehicles close enough

so the jumper cables can reach,
but be sure the vehicles are not
touching each other. If they are,
it could cause a ground
connection you do not want. You
would not be able to start your
vehicle, and the bad grounding
could damage the electrical
systems.

To avoid the possibility of the
vehicles rolling, set the parking
brake firmly on both vehicles
involved in the jump start
procedure. Put the automatic
transmission in P (Park) or a
manual transmission in
N (Neutral) before setting the
parking brake. If the vehicle has
a four-wheel-drive transfer case
with a N (Neutral) position, be
sure the transfer case is in a
drive gear, not in N (Neutral).

Advertising