Caring for your oven, The oven lights, Electrical shock hazard – Whirlpool RBS307PD User Manual
Page 42: To replace an oven light, Warning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
C A R I N G F O R Y O U R O V E N
PART
WHAT TO USE
HOW TO CLEAN
Oven door glass
Paper towel and spray
• Make sure oven is cool.
glass cleaner
• Follow directions provided with the
OR
cleaner.
Warm, soapy water and • Wash, wipe with clean water, and dry
a nonabrasive, plastic
scrubbing pad
thoroughly.
Oven cavity
Self-Cleaning cycle
• See “Using the Self-Cleaning Cycle” on
pages 33-40.
The oven lights
The oven lights will come on when you open
the oven door. To turn the lights on when
the oven door is closed, press the Oven
Light Pad j^jon the control panel.
^WARNING
Electrical Shock Hazard
• Make sure oven and light bulb are
cool and power to the oven has been
turned off before replacing the light
bulb.
•The light cover must be in place when
using the oven. The cover protects
the bulb from breaking, and from high
oven temperatures. Because the light
cover is made of glass, be careful not
to drop it.
Failure to follow the above could result
in electrical shock, burns, or injury from
broken glass.
To replace an oven light:
1. Disconnect appliance at the main power
supply.
2. Remove glass light cover by grasping
rear or back edge of cover and pulling it
away from the side wall of the oven.
3. Remove the light bulb from its socket.
Replace the bulb with another halogen
bulb (12 volt, 5 watt maximum, available
at most hardware stores).
4. Replace the light cover by snapping it
back into wall. Reconnect appliance at
main power supply.
NOTE: The oven lights will not work during
the Self-Cleaning cycle.
42