Industry compliance, Crestron chv-tstatrf infinet™ thermostat – Crestron electronic CHV-TSTATRF User Manual

Page 11

Advertising
background image

Crestron CHV-TSTATRF

infiNET™

Thermostat

Industry Compliance

As of the date of manufacture the CHV-TSTATRF has been tested and found to
comply with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling.

FCC ID: EROCWD1013

Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:

1. This device may not cause harmful interference and
2. This device must accept any interference received, including interference

that may cause undesired operation.

Warning (Part 15.21)
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.

FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:

1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

4. Consult the dealer or an experienced radio/TV technician for help.

FCC Statement
To comply with FCC’s RF exposure limits for general population / uncontrolled
exposure, the antenna(s) used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter.

Industry Canada Statement
The term “IC” before the certification/registration number only signifies that the
Industry Canada technical specifications were met
IC: 5683A-CWD1013

Section 7.1.5 of RSS-GEN
Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference

that may cause undesired operation.

Operations & Installation Guide – DOC. 6490A

infiNET™ Thermostat: CHV-TSTATRF

7

Advertising