Crestron electronic CHV-TSTATRF - Manual (Page 26)

infiNET™ Thermostat Crestron CHV-TSTATRF
Setup Mode Parameters/Functions (Continued)
PARAMETER/
FUNCTION
CODE VALID VALUES
DEFAULT
VALUE
NOTES
Power Source Po 24V always available
(24) or steal power
(SP) 24 Selects source of input power for
thermostat. 24VAC assumes
constant power is available
between the C and RH
connectors. The steal-power
function allows recovery of some
power from the HVAC system
when constant power is not
available. Steal power may not
work with some zone controllers.
In this case, set value to “24” and
ensure that you have two AA
batteries installed.
Check Firmware
Version rE Firmware version is
displayed in xx.yy.zz
format. “—“ can also
be displayed -- When firmware version is not yet
shown, display will be “—“. Each
press of the or button will
cycle to the next portion of the
version number.
infiNET ID (MNET ID) id 01 and 03 – FE 01 Sets the infiNET ID. SIMPL
Windows restricts infiNET
devices to an ID range of 03 –
20.
infiNET RF Channel CH 11-26 for fixed-channel
operation, “Au” for auto
or “0” for disabled
(battery saver) 26 Selects the RF channel. A fixed
channel allows faster setup and
reconnect when the gateway
channel is fixed. Auto channel
allows more flexibility but may
consume slightly more power if
network communications are
interrupted. A setting of “0”
disables the radio.
infiNET Sleep Time SL Short (S) or Long (L) L Indicates thermostat update rate.
Setting for fewer updates (“L”) will
conserve battery power.
Start infiNET Acquire AC Not started (--)
In progress (flashing --
)
Finished, found GW
(00)
Finished, could not find
GW (E#, where #
represents an error
code) N/A Used to acquire the device to a
gateway.
”E0” indicates that search time
has expired and no gateway was
found.
”E1” indicates the infiNET RF
Channel is set to “0” (disabled).
Unacquire Gateway UA Not started (--)
In progress (flashing --
)
Finished, success (00)
Finished, failed (E#,
where # represents an
error code) N/A Used to remove gateway
information from the device, so it
will no longer communicate with
the current gateway.
”E0” indicates that there is no
previous gateway information (i.e.
the gateway may already have
been unacquired).
(Continued on following page)
22 • infiNET™ Thermostat: CHV-TSTATRF Operations & Installation Guide – DOC. 6490A