Cadillac SRX 2010 - Manual (Page 344)

Black plate (38,1) Cadillac SRX Owner Manual - 2010
9-38 Vehicle Care
Low-Beam Headlamps/Daytime
Running Lamps (DRL),
High-Beam Headlamps (Base)
1. Remove the top cap for the
low-beam headlamp/DRL bulb
replacement from the back of the
headlamp assembly.
2. Remove the bottom cap for the
high-beam headlamp bulb
replacement from the back of the
headlamp assembly.
3. Disconnect electrical connector.
4. Remove the bulb socket from
the headlamp assembly.
5. Replace the bulb in the bulb
socket.
6. Install the bulb socket in the
headlamp assembly.
7. Connect the electrical connector.
8. Install the cap with the down
arrow pointing down in the back
of the headlamp assembly.
9. For driver side, reinstall the
underhood electrical center
cover by latching three clips.
10. For passenger side, reinstall
the air filter/cleaner assembly
base by pushing to seat. Verify
the base is seated securely,
then install the engine air
filter/cleaner assembly.
High/Low‐Beam Headlamps
(Up-Level)
The high/low beam headlamps on
the up-level are High Intensity
Discharge (HID) and should be
replaced at the dealer.