Kenmore SWA/RS 14501 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Pick up the Bobbin Thread
1. Raise the presser foot lever.
2. a. Hold the top thread loosely in your left
hand.
b. With your right hand, rotate the hand
wheel toward you until the take-up lever
has come to the top again.
3. a. Pull the top thread with your left hand to
bring up the bobbin thread.
b. Pull the bobbin
comes through
needle plate.
thread until the end
the opening of the
4. Pull both threads under the presser foot
toward the back of the machine.
If you did not pick up the bobbin thread with the above steps, check your method
with the questions below:
1. Is the thread through the eye of the needle (front to back) ?
2. Isn't the thread tangled around the needle ?
3. Is the bobbin inserted in its case with the thread running counter clockwise ?
4. Is the thread pulled underneath the bobbin case tension spring ?
5. Isn't the thread in the bobbin tangled ?
6
. Are there 3 to 4 inches of thread coming out of the bobbin case ?
After checking all of the questions above, repeat steps 1 to 4.
16