Button sewing – Kenmore SWA/RS 14501 User Manual
Page 34
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Button sewing
1. Attach the feed cover plate (see page 20).
2. Use clear tape to fix the button on your
fabric before stitching.
NOTE: When sewing a fiat button, piace
a pin between the holes so your
button will be loose enough for
easy buttoning.
3. Align the two holes of the button with the
slot of the presser foot.
4. Lower the presser foot.
5. Turn the hand wheel by hand until the
needle point is just above the button.
6
. Adjust the stitch width control so the
needle will enter one hole of the button.
7. Turn the hand wheel again so the needle
will enter the second hole. Readjust the
stitch width if necessary.
8
. Stitch several times.
9. Leave 2 inches of thread after stitching.
10. Pull these threads under the fabric and tie
secureiy.
32