Kenmore SWA/RS 14501 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Change the presser foot
Snap-on presser feet
1. Bring the needle to the up position.
2. Raise the presser foot lever.
3. Push the foot release lever and the presser
foot will drop off.
4. Place the new foot on the needle plate
aligning needle holes.
5. Lower the presser foot lever so that the
presser foot holder snaps on the foot.
6
. Push down the presser foot thumb screw
to engage the foot holder and the foot
securely.
Screw-type presser feet
To use some accessory feet (see page
6
), you
may need to remove the presser foot holder.
1. Bring the needle to the up position.
2. Raise the presser foot lever.
3. Turn the presser foot thumb screw toward
the back of the machine using the large
screw driver.
4. Remove the presser foot holder.
5. Insert the new foot.
6
. a. Lower the presser foot lever.
b. Tighten the thumb screw using the
screw driver to fit the foot securely.