Kenmore SWA/RS 14501 - Manual (Page 53)

■ ■
Set up the machine
Top thread tension control Stitch width control Stitch selector
1. a. Remove the extension table.
b. Raise the needle to its highest position.
c. Remove the presser foot.
d. Position the feed cover plate in place.
2. a. Open the bobbin access cover.
b. Make sure the lock lever of the
buttonhole adapter is at the right
released position.
c. Pulling the density control knob toward
you, insert the two hooks of the
buttonhole adapter between the two
pins located under the needle plate.
d. Push the lock lever away from you until
i the adapter snaps into place.
51