Kenmore 70089 - Manual (Page 17)

Installation
Figure 29. Installing Seal Strip
1. Seal strip
2. Outdoor sash
3. Indoorsash
12. See Figure 30. Under normal conditions, unit can
evaporate water as fast as it is removed from indoor
air. In very humid conditions, however, excess water
may drip off chassis. To avoid dripping, instail
condensate drain cup (included with unit). Insert
condensate drain cup through Va" hole recessed in
flange on right side of outer case bottom. Then
place Vi" diameter hose or tube on bottom spout of
drain cup.
into outer case. Attach base pan retaining clip to
chassis with V4" screw. Reinstall front frame, air
filter, and front grille. Because window sash helps
keep unit in window, make sure sash contacts case
before reinstalling chassis.
14. To be sure air conditioner installation is correct,
review all steps and ensure all parts are securely
fastened, as outlined in instructions. If final
inspection shows installation is solid and complete,
air conditioner can be operated safely.
To begin operation, plug unit into electrical outlet.
Figure 30A. Attaching Chassis To Outer Case
1. Front frame
2. Base pan clip
3. Base pan handle
4. Chassis
Through-the-Wall Installation—12000, and
18000 Btu Units
(Models 70129, and 78189)
Kenmore Room Air Conditioners with slide-out chassis
cases (models 70129, and 78189) are designed to be
install^ in a window or through a wall. Following are
instructions are for wall installation.
NOTE: Kenmore Room Air Conditioner Models 78079 and
70089 (7000 and 9000 Btu) are designed for
window installation only. See instructions
beginning on page 7.
Typical Cabinet Dimensions
Figure 31. Slide-Out Chassis Outer Case Dimensions
12000 Btu 18000 Btu
1. 9 inches 14Vfe inches
2. 16Vi inches 19Vfe inches
3. 23% inches 25% inches
4. 23Vi6 inches 28 V^ inches