Kenmore GENIUS II 625.34867 - Manual (Page 12)

SECTION 2
HOW YOUR WATER SOFTENER WORKS
2A. FACEPLATE TIMER FEATURES
OTHER FEATURES
TANK LIGHT
To light the inside of the salt
storage tank, press the TANK
LIGHT button on the faceplate.
Press the same button again to
turn the light off, or it will go off
automatically in 4 minutes.
rfkfi
a
7 6
1.Q8*
4
3
2
t
tank light ON
indicator
WATER FLOW RATE THROUGH SOFTENER
To view the gallon (or liter) per minute water flow rate
through the softener, if not already displayed, press
the #2 SELECT button. If soft
water is being used, the flow rate
to the closest 1/10 gallon (or
liters) shows. If all faucets and
water using appliances are off,
the display will show 0 flow.
IQS'
3
.
8
‘
M r
■ "i* ‘ 1
6
“108
*
4
s
2
r
188
AVG. DAAyQAllOHS
AVERAGE DAILY GALLONS
or LITERS
Press the #2 SELECT button again
to show the average number of
gallons of soft water the household uses each day.
This water usage figure is adjusted daily by the
faceplate timer. To turn this display off, press the #2
SELECT button once more.
LOW SALT INDICATOR LIGHT
When on, you need to refill the salt storage area with
salt. After refilling, reset the salt monitor to turn the
light off. Refer to Salt Monitor System, page 10.
PROGRAM MEMORY
If electrical power to the softener goes off, the time
display is blank but the faceplate timer keeps the
correct time for about 72 hours. When electrical power
comes on again, you have to reset the present time
only if the display is flashing. The HARDNESS and
RECHARGE TIME never require resetting unless a
change is desired.
Even if the timer is incorrect after a long power outage,
the softener works as it should to keep your water soft.
However, regenerations may occur at the wrong time
of day until you reset the timer to the correct time of
day.
ERROR CODE
An error code could appear in the
faceplate display if a problem
occurs in the softener electronics.
If you see an error code instead of
the present time of day, please
call you local Sears Service De­
partment for service.
Err3
valve
position
indicators
V
recharge
time
remaining
È
RECHARGE TIME REMAINING and VALVE
POSITION INDICATORS
One of the valve position indica­
tors (Serv, Fill, Brine, Bkwsh,
Rinse) is displayed while the
softener
is recharging (See
♦NOTE on page 10 if the CLEAN
feature is set to ON). RECHARGE
flashes in the display and, begin­
ning with Brine, the minutes of recharge remaining
before return to service appears in place of the present
time. When the valve is moving from one cycle to
another, both position indicators are flashing.
12