Kenmore GENIUS II 625.34867 - Manual (Page 18)

SECTION 3
CARE OF YOUR SOFTENER
3C. KEEP THE SOFTENER FROM FREEZING
If the softener is installed where it could freeze
(summer cabin, lake home, etc.), you must drain all
water from it to stop possible freeze damage. To drain
the softener —
1. Close the shut-off valve on the house main water
pipe, near the water meter or pressure tank.
2. Open a faucet in the soft water pipes to vent
pressure in the softener.
3- Refer to FIG. 12 on page 20. Move the stem in a
single bypass valve to bypass. Close the inlet and
outlet valve in a 3-valve bypass system, and open
the bypass valve. If you want water in the house
pipes again, reopen the shut-off valve on the main
water pipe.
4. Unplug the transformer at the wall outlet. Remove
the salt hole cover and the main cover. Take off
both drain hoses.
5. Carefully remove the large holding clips at the
softener inlet and outlet (see Key No. 69, on page
32). Separate the softener from the copper tubes,
or from the bypass valve.
6
.
Remove the brinewell cover and disconnect the
brine valve tubing at the nozzle and venturi
assembly (see page 32). Lift the brine valve out of
the brinewell. Tip the brine valve upside down to
drain water.
FIG. 11 DRAIN WATER FROM THE
SOFTENER
8
.
Looking at FIG. 11, lay a piece of 2 inch thick
board near the floor drain. Move the softener close
to the drain. SLOWLY and CAREFULLY, tip it over
until the rim rests on the wood block with the inlet
and outlet over the drain. Do not allow the
softener’s weight to rest on the inlet and
outlet fittings or they will break.
Tip the bottom of the softener up a few inches and
hold until all water has drained. Leave the softener
laying like this until you are ready to use it. Plug
the inlet and outlet with rags to keep dirt, bugs,
etc. out.
18