Kenmore GENIUS II 625.34867 - Manual (Page 13)

SECTION 2
HOW YOUR WATER SOFTENER WORKS
2B. SOFT WATER SERVICE AND REGENERATION
SERVICE
When the softener is giving you soft water, it is called
"Service”. During service, hard water comes from the
house main water pipe into the softener. Inside the
softener resin tank is a bed made up of thousands of
tiny, plastic resin beads (FIG. 4). As hard water passes
through the bed, each bead attracts and holds the
hardness minerals. This is called ion-exchanging. It is
much like a magnet attraaing and holding metals.
Water without the hardness minerals (soft water) flows
out of the softener and into the house soft water pipes.
After a period of time, the resin beads become coated
with hardness minerals and they have to be cleaned.
This cleaning is called regeneration or recharge.
Regeneration is started at 2:00 a.m. by the electronic
timer (see page 15). It takes place in 5 stages or cycles.
These are;
1 FILL 4
2 BRINING 5
3.
BRINE RINSE
BACKWASH
FAST RINSE
NOTE:
If the Clean feature is set to ON, additional backwash
and fast rinse cycles occur before the fill cycle.
FIG. 4 WATER FLOW THROUGH THE
SOFTENER IN SERVICE
soft water hard water
OUT IM
resin tank
resin bed
REGENERATION
m FILL: Salt, dissolved in water, is called brine.
Brine is needed to clean the hardness minerals from
the resin beads. To make the brine, water flows into
the salt storage area during the fill stage as shown in
FIG. 5. Fill cycle length depends on how much soft
water making capacity you have used since the last
regeneration. As you use more water, fill time
increases so more brine is made. The greater amount
of brine cleans more hardness minerals from the resin
bed.
FIG. 5 WATER FLOW THROUGH THE
SOFTENER IN FILL
soft water hard water
OUT IN
13