Cleaning the washer proper use of detergent, Care and cleaning of the washer, Care and cleaning – Kenmore ELITE 796.292796 User Manual

Page 25: Proper use of detergent

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

CARE AND CLEANING

CLEANING THE WASHER

Proper Use of Detergent

Using too much detergent is a common cause of laundry problems. Today’s detergents are formulated to be effective

without visible sudsing. Be sure to carefully read and follow manufacturer’s recommendations for how much detergent to

use in your wash.

You can use less detergent if you have soft water, a smaller load, or a lightly soiled load.

NOTE:

Use only low-sudsing, highefficiency detergent such as Tide® HE.

Care and Cleaning of the Washer

Lid:

Wash with a damp cloth on the outside and inside and dry with a soft cloth.

Exterior:

Immediately wipe off any spills. Wipe with damp cloth. Do not touch the

surface or the display with sharp objects.

Moving and Storage:

Ask the service technician to remove water from drain pump

and hoses. Do not store the washer where it will be exposed to the weather.

Long Vacations:

Be sure water supply is shut off at the faucets. Follow the instruc­

tions on page 24 if the washer will be exposed to freezing temperatures.’

m

z

o

r

(7)

Dispenser Drawer:

Detergent and fabric softener may build up in the dispenser

drawer. Remove the drawer and check for buildup once or twice a month.

^ Remove the drawer by pulling it straight out until it stops. Lift up on the front of

the drawer and pull it out.

O

Remove the inserts from the 2 compartments; rinse the inserts and the drawer

with warm water to remove built up laundry products.

e

To clean the drawer opening, use a small, non-metal brush to clean the recess.

Remove all residue from the upper and lower parts of the recess.

Q

Return the inserts to the proper compartments and replace the drawer.

Set the drawer into the opening at an angle as shown above, then lower it and
slide it into place.

25

Advertising