Pioneer GM-X952 - Manual (Page 10)

Installation
CAUTION
• Do not install in:
—Places where it eould injure the driver or pas­
sengers if the vehiele stops suddenly.
—Plaees where it may interfere with the driver,
sueh as on the floor in front of the driver’s
seat.
• Make sure that wires are not eaught in the sliding
meehanism of the seats, resulting in a short-eir-
euit.
• Confirm that no parts are behind the panel when
drilling a hole for installation of the amplifier.
Proteet all eables and important equipment sueh
as fuel lines, brake lines and eleetrieal wiring
from damage.
• Install tapping serews in sueh a way that the
serew tip does not toueh any wire. This is impor­
tant to prevent wires from being eut by vibration
of the ear, whieh ean result in fire.
• To prevent eleetrie shoek, do not install the ampli­
fier in plaees where it might eome in eontaet with
liquids.
• To ensure proper installation, use the supplied
parts in the manner speeified. If any parts other
than the supplied ones are used, they may damage
internal parts of the amplifier, or they may
beeome loose eausing the amplifier to shut down.
To prevent malfunction
• To ensure proper heat dissipation of the amplifier,
be sure of the following during installation.
—Allow adequate spaee above the amplifier for
proper ventilation.
—Do not eover the amplifier with a floor mat or
earpet.
• Do not install the amplifier near a door where it
may get wet.
• Do not install the amplifier on unstable plaees
sueh as the spare tire board.
• The best loeation for installation differs with the
ear model and installation loeation. Seeure the
amplifier at a suffieiently rigid loeation.
• Make temporary eonneetions first and eheek that
the amplifier and the system operate properly.
• After installing the amplifier, eonfirm that the
spare tire, jaek and tools ean be easily removed.
Example of installation on the floor
mat or on the chassis_____________
1. Place the amplifier where it is to he
installed. Insert the supplied tap­
ping screws (4
X 18 mm) into the
screw holes. Push on the screws with
a screwdriver so they make marks
where the installation holes are to
he located.
2. Drill 2.5 mm diameter holes at the
point marked, and install the ampli­
fier, either on the carpet or directly
to the chassis.
Tapping-screws
(4
X 18 mm)
Spanningsindicator
Floor mat
or chassis
De spanningsindicator licht op wanneer
de spanning wordt ingeschakeld.
Schakelaar voor de regeling van
de slagfrequentie (BFC)_________
Als u een slag of dreun hoort bij het
luisteren naar een MW/LW (MG/LG)-
uitzending
Op uw autostereo, kunt u de
stand van de BFC-schakelaar wijzigen
met een kleine schroevedraaier met
platte kop.
f
LPF(lage-doorlaatfilter)-keuzeschakelaar
Stel de LPF-keuzeschakelaar als volgt in, naargelang het type luidspreker dat is aangesloten
Op de luidsprekeruitgangsaansluiting en het autostereosysteem:
LPF-keuze- Uit te voeren
sdiakelaar audio freiiuentiebereik
Type
luidspreker
Opmerkingen
LPF (links) Zeer laag frequentiebereik Subwoofer Sluit een subwoofer aan.
Uitgescha keld (OFF) Full range
(reehts) Full range
V у