Note, Average current drawn, Instellen van dit toestel specifications – Pioneer GM-X952 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Instellen van dit toestel
Specifications
Versterkingsregelaar
Draai de versterkingsregelaar op het
voorpaneel van de eindversterker naar
rechts indien de weergave te zacht
klinkt, zelf wanneer het volume is ver-
hoogd met de auto-stereo die u met deze
eindversterker gebruikt.
Draai de versterkingsregelaar naar links
indien het geluid vervormt wanneer het
volume wordt verhoogd.
• Wanneer u een auto-stereo gebruikt met
RCA (standaard uitgangsspanning 500 mV),
dient u de NORMAL stand in te stellen.
Wanneer u een Pioneer auto-stereo met
RCA gebruikt, met een maximale uit
gangsspanning van 4 V of meer, dient u
het niveau aan te passen aan het uit-
gangsniveau van de auto-stereo.
Power source ...........................................................................................14.4 V DC (10.8 — 15.1 V allowable)
Grounding system.......................................................................................................................Negative type
Current consumption .................................................................................... 25.0 A (at continuous power, 4 f})
Average current drawn* ....................................................................................... 8.4 A (4 for two channels)
14.5 A (4 for one channel)
Fuse ................................................................................................................................................... 25 A
X
2
Dimensions ...................................................................................................... 279 (W) x 58 (H) x 324 (D) mm
Weight ..................................................................................................... 4.8 kg (Leads for wiring not included)
Maximum power output................................................................................................ 200 W x 2 / 600 W x 1
Continuous power output ......................................................... 150 W x 2 / 450 W x 1 (DIN45324, -i-B=14.4 V)
Load impedance .........................................................................................................4f}(2 — 8f} allowable)
(Bridge connection: 4 — 8 allowable)
Frequency response.......................................................................................... 10 — 50,000 Hz (-tO dB, -1 dB)
Signal-to-noise ratio ...................................................................................................100 dB (lEC-A network)
Distortion....................................................................................................................... 0.008 % (10 W, 1 kHz)
Separation.................................................................................................................................. 65 dB (1 kHz)
Low pass filter............................................................................................................ Cut off frequency: 80 Hz
Cut off slope: -12 dB/oct
Maximum input level/impedance .................................................................. RCA: 6.5 V/22 kf} (0.4 — 6.5 V)
Note:
• Specifications and the design are subject to possible modification without notice
due to improvements.
^Average current drawn
• The average current drawn is nearly the maximum current drawn by this unit
when an audio signal is input. Use this value when working out total current
drawn by multiple power amplifiers.