Uniden UBC9000XLT - Manual (Page 54)

Troubleshooting
If your UBC9000XLT is not performing properly, try the steps listed below.
PROBLEM SUGGESTION
Scanner won’t work. Check the conrwctions at both ends of
the AC Adaptor.
Turn on the wall switch of your room.
Move the AC Adaptor to another
wail outlet.
Make sure the power switch is turned on.
Poor reception.
Check the antenna and its connection.
You may be in a fringe area. This may
require an optional multi-band
antenna. Check with your dealer or
local electronics store.
Scan won’t stop.
Adjust the Squelch Control,
Check the antenna connection.
It is possible that none of the
programmed channels are active at the
time. Try the band search.
Scan won’t start. Press the bank key again.
Make sure there are some
programmed channels.
Adjust the Squelch Control.
Search won’t start. Adjust the Squelch Control.
Scanner won’t allow any program
inputs
Check the Enter Lock feature.
Can't program channel with alpha
character
Alpha character programming is available
up to 250 channels. Make sure the
programmed channel is within that range.
I
If you still cannot get satisfactory results and want additional information,
or to return the unit for service, please call Uniden Customer Service
Division. The address and phone number are listed in the Warranty.
(at the end of this manual)
51