Fm outdoor antenna, Fm de.emphasis/channel space table, Fm de-emphasis/channel space switch 1 – Kenwood KR-V9020 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FM outdoor antenna
Be sure to use an outdoor FM antenna to receive good
sound quaiity FM broadcasts with a mininnum of noise.
When connecting an outdoor antenna to the antenna
terminals of this unit, use a 75 ohm/300 ohm antenna
adaptor connected to the coaxial cable as illustrated. The
75 ohm/300 ohm antenna adaptor is supplied with this
unit. Be sure to connect the coaxial cable to the adaptor
as instructed below.
'
■ 75 ohm coaxial cable connection (Follow the order of numbers.)
Note: ------- ------------------—----------------------------------------------- ------------
An FM outdoor antenna can be connected to the receiver with
either a 75 ohm coaxial cable or a 300 ohm ribbon feeder. For
proper connection, carefully read the instruction manual pro
vided with outdoor antenna.
©
Arrange the coaxial cable as illus
trated.
Outer shield
(Braid)
Inner
conductor
RG-6 (5C-2V) or RG-59 (3C-2V)
©
Open the 75 ohm/300 ohm an
tenna adaptor cover.
Press the claws in the direction of
the arrows with the fingers to re
lease the lock and pull out the cover.
Claw
© Cut off the red wire and remove it
from the clip.
\V/
/ R®eiove the
U// / red wire
©
Connect the processed coaxial ca
ble to 75 ohm/300 ohm antenna
adaptor as shown below.
Insert the inner conductor
into the slot on the clip.
©
Secure the holders A and B,
Close the cover.
Wire mesh
Outer shield
Holder B
Holder A
Area
Channel
Space Frq,
FM
DE-EMPHASIS
1,
U.S.A.
Canada and
FM: 100 kHz
South Ameri
can
countries
AM: 10 kHz
7 5 /AS
2.
Other
countries
FM: 50 kHz
AM: 9 kHz
50 /AS
FM DE.EMPHASIS/CHANNEL SPACE table
75
ms
50
ms
lOkHz
DE-
EMPHASIS
9kHz
AM
CHANNEL
lOOkHz
50kHz
FM
SPACE
■ FM DE^EMPHASIS/CHANNEL SPACE
switch (Except for some areas.)
The FM DE-EMPHASIS/CHANNEL SPACE switch on the
rear panel is set to the correct setting that prevails in the
area to which the unit is shipped. Fjowever, if the FM
DE-EMPHASIS/CHANNEL SPACE setting is not matched
to the area where the unit is to be used (for instance, if you
move from area 1 to area 2 or vice versa), desired
reception of AM/FM broadcasts cannot be expected. In
this
case,
change
the
FM
DE-EMPHASIS/CHANNEL
SPACE setting in accordance with the area corresponding
to the table on the left,
The FM DE-EMPHASIS setting is switched over at the
same time.
Note: -------------------- ------—---------------------------------------- ------ ----------
When changing the setting of the FM DE-EMPHASIS/CHANNEL
SPACE switch, first disconnect the power cord, then reset the
channel space switch, connect the power cord again, and turn
the power on.