Kenwood KR-V9020 User Manual
Page 40
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Remote control operation
LEARH , , USE
on
ll=llTBAK5MIT
mm
■ To program the remote control functions
of other remote control units into the
RC-120:
I.Set the LEARN/USE select switch to the LEARN
position, and set the AUDIO/VIDEO/AUX select switch
to the desired position.
Other remote
control unit
5 cm
2. Place the RC-1 20 and the other remote control unit so
that their heads (transmission ends) face each other.
(Leave a distance between the units of about 2 "^5 cm
or 0.8 ^ 2 inches.)
3, Press one of the learning keys on the RC-120. The
LEARN indicator will light.
Example; To program the REPEAT key of the other
remote control unit
Hold the key
depressed
4. Press the key to be programmed on the other remote
control unit and hold it depressed.
REPEAT function is stored under this key
Goes out'
61
1 (i
D '
m
A
BOTl p a
|| e p a imMMMl!
m
E 3-11 pa
E f
Pa
fajOTCIDGsQiBl
5. When the LEARN indicator on the RC-1 20 blinks twice
and then goes out, the programming operation is
completed. When the programming operation is com
pleted, release your finger from the key on the other
remote control unit.
Note: ----------------------------------------------------------------------------------------
Be sure to hold the key to be programmed on the other remote
control unit depressed until the LEARN indicator goes out.
• To program other remote control functions, repeat the
procedure outlined in steps (3) to (5).